====== Neptune4 ======

{{imgpaste:202510:htmikan-20251019-191754.png?400}}

===== LED修正メモ =====

1.Add these to your printers home/mks folder.
Open Putty and run bash install.sh (Its normal if it returns an oooopsie,just move on)
Remove lines in printer.cfg about flashlight and replace with these:
[gcode_shell_command hotend]
command: sh /home/mks/toggleled.sh
timeout: 30.
verbose: True

[gcode_shell_command overhead]
command: sh /home/mks/toggleovr.sh
timeout: 30.
verbose: True

[gcode_macro Hotend LED]
description: Turn on Hotend LEDs
gcode:
  RUN_SHELL_COMMAND CMD=hotend

[gcode_macro Overhead LED]
description: Turn on Hotend LEDs
gcode:
  RUN_SHELL_COMMAND CMD=overhead
4: Profit